Table of Contents
Advertisement
Precautions for Handling of Bluetooth Equipment
■
Note the following points to ensure good connection
status:
Q Ensure about 10 m of line-of-sight distance from coupled Bluetooth
device. Connectable range may be narrower depending on
surrounding environment (walls and furniture etc.) and building
structure, or if there is any obstacle between the FOMA terminal and
Bluetooth device to be coupled.
They may not be coupled if they are in different floors or rooms divided
by ferroconcrete walls. No warranty is given as to the connection
distance stated above.
Q Use Bluetooth devices away from other devices (electric/AV/OA
equipment) as possible. (As the devices are easily affected by
microwave in use, so keep your devices away from any microwave.)
Otherwise, improper coupling, TV or radio noise and reception fault
may be caused. (TV picture is distorted for certain channels of UHF
and satellite broadcasting.)
Q When devices are not coupled properly due to any broadcasting
station or radio transmitter near you, please relocate the counterpart
Bluetooth device. Coupling may fail if the device is surrounded by
strong radio wave.
Q Wireless connection is possible with Bluetooth device put in any bag
or pocket. However, decreased transmission speed or noise may be
resulted when your body is in between Bluetooth device and the
FOMA terminal.
■
Radio wave interference with wireless LAN
As Bluetooth and wireless LAN (IEEE802.11b/g) use the same
frequency band (2.4 GHz), use of Bluetooth device around wireless
LAN ready equipment may cause radio wave interference, leading to
decreased communication speed, noise or connection failure. In this
case, take actions below:
Q Make sure to keep the FOMA terminal and Bluetooth device to be
coupled 10 m away from wireless LAN equipment.
Q Otherwise, turn off wireless LAN equipment.
■
Radio wave transmitted from Bluetooth device may affect
operations of medical electronics.
As this may cause an accident in some instances, be sure to turn off
your FOMA terminal and Bluetooth device(s) in the following locations:
Q In train
Q In aircraft
Q In hospital
Q Near auto door or fire alarm
Q Any place where flammable gases may be present (i.e. gas station)
Connection with Bluetooth Equipment
Data can be exchanged with Bluetooth ready PC and cell phones
via Bluetooth communication. You may also connect Bluetooth
head set through Bluetooth communication for handsfree talk and
music playback.
Q Be sure to turn ON the Bluetooth feature of the device to be coupled
and check it can be coupled.
W
x
A
1
Home screen
W
networks]
Select [Bluetooth] checkbox
[Bluetooth settings]
Bluetooth setting screen is displayed.
2
[Scan for devices]
Q Detected Bluetooth device(s) are listed in the Bluetooth device
list.
Q Select [Discoverable] checkbox to allow for detection of the
FOMA terminal from other Bluetooth devices for about 120
seconds.
3
Tap a detected Bluetooth device
W
(PIN) if prompted
[OK]
Q If any Bluetooth device to be coupled also requires passcode
(PIN), enter corresponding passcode (PIN).
W
W
[Settings]
[Wireless &
W
W
Enter passcode
Data Communication
87
Advertisement
Table of Contents
