Eco Setting - NEC Express 5800 Series User Manual

BMC Configuration User's Guide
7.7

ECO setting

-- The electric power value might not necessarily reach even the value of Power Threshold. The electric
power control lowers the power consumption of the system by lowering the frequency of CPU/Memory.
When CPU/Memory Throttling value reaches 100%, the electric power value does not fall any more.
-- The server may not boot correctly if you configure too low value to the Aggressive Mode "Power
Threshold(Pa)" and enable the Shutdown System option. When validating this setup, it is recommended to
fully consider the value of "Power Threshold(Pa)" to be specified.
-- The following case, ECO settings are not supported and not displayed.
"Operating System is Windows Server 2003(R2)." and "NEC ESMPRO Agent is installed."
7.8
Management LAN setting
-- When set to "Shared BMC LAN", the management LAN port is disabled.
-- When set to "Shared BMC LAN", the network performance may be reduced because the data of both
LANs must be transmitted or received.
7.9
Miscellaneous setting
-- If you set 100 or greater to "Power On Delay Time" on the Server menu of the BIOS SETUP utility, and
make the Miscellaneous setting in Off-line TOOL, an error may occur. In this case, set 99 or less to "Power
On Delay Time" temporarily, and then make the Miscellaneous setting. After that, set "Power On Delay
Time" again as needed.
7.10
Network / Service setting
-- When you change the Network setting or the Service setting on the EXPRESSSCOPE Engine SP3, an error
may occur depending on the load status of the system. In this case, please check the setting and set again
as needed.
7.11
Default setting
-- Please refer to the appropriate EXPRESSSCOPE Engine User's Guide about differences between BMC
Configuration's default values and values which "BMC Configuration Initialization" function will set.
7.12
Key input
-- If you select the keyboard type "Japanese" in Off-line TOOL startup, you are not able to enter the key of
"¥", "|" and "_".
-- In BMC Configuration for Windows, if you want to apply a string containing "%", you must specify "%%"
instead of "%".