Connecting To Network - Honeywell XYR 6000 User Manual

3.1 Installation
Refer to the XYR 6000 Transmitter Quick Start Guide (document 34-XY-25-21) for installation, mounting
and wiring of your XYR 6000 transmitter.
3.2 Configuration
The XYR 6000 Transmitter contains the electronics interface compatible for connecting to the
OneWireless network. An operator uses the One Wireless UI application to configure blocks and to
change operating parameters. These changes are written to the transmitter when it is authenticated by a
security key.
3.3

Connecting to network

Use Provisioning Device to connect your transmitter to the OneWireless network. See page 29.
3.4 Calibrating the transmitter
Methods of calibration
Calibration can be done at the transmitter or at One Wireless User Interface. For all calibration methods at
the transmitter, One Wireless UI must be used to disable write protect and take the channel out of service.
Calibration applies only to the thermocouple/millivolt and HLAI input, not to the discrete inputs.

User calibration - Calibrates the channel to the low and high range values for the selected channel's
input type.

Restore calibration - Calibration constants for the selected channel are restored to factory defaults.

Clear calibration - Factory or user calibration constants for the selected channel are cleared.
Additional calibration commands are available in One Wireless User Interface.
Revision 1
January 2011
3. Preparation
User's Manual
3. Preparation
3.1. Installation
11