Restore Calibration - Honeywell XYR 6000 User Manual

3. Preparation
3.4. Calibrating the transmitter

Restore calibration

Step
In OneWireless UI, set the transmitter's Software Write Protect to Disable.
1
In OneWireless UI, set the transmitter's channel to Out of Service.
2
At the transmitter display, verify the channel's PV value is not displayed.
3
Use Provisioning Device's Device Local Configuration buttons to navigate to the transmitter's
CAL menu.
If the channel is not out of service a WRONG MODE message will be displayed. Go to step 2.
If the transmitter is write protected a LOCKED message will be displayed. Go to step 1.
Select the channel (CH 1, CH 2 or CH 3).
4
Select CAL RSTR
Press Enter to continue.
Display will say BUSY, then SUCCESS.
If unsuccessful the display will show BAD_FACTORY_CALIBRATION.
When ready, in OneWireless UI return the transmitter's channel to service and set Software
5
Write Protect to Enable.
Clear calibration
Step
In OneWireless UI, set the transmitter's Software Write Protect to Disable.
1
In OneWireless UI, set the transmitter's channel to Out of Service.
2
At the transmitter display, verify the channel's number and PV value is not displayed.
3
Use Provisioning Device's Device Local Configuration buttons to navigate to the transmitter's
CAL menu.
If the channel is not out of service a WRONG MODE message will be displayed. Go to step 2.
If the transmitter is write protected a LOCKED message will be displayed. Go to step 1.
Select the channel (CH 1, CH 2 or CH 3).
4
Select CAL CLR
Press Enter to continue.
Display will say BUSY, then SUCCESS.
Repeat for each channel desired.
When ready, in OneWireless UI return the transmitter's channel to service and set Software
5
Write Protect to Enable.
16 XYR 6000 ISA100.11a Compliant Universal I/O Transmitter User's Manual
Action
Action
Revision 1
January 2011