Transmitter Connection Status - Honeywell XYR 6000 User Manual

5. Operation

5.2. Transmitter connection status

5.2 Transmitter connection status
Displayed Definition
status
NO KEY Transmitter needs a key from the
Provisioning Device and is not transmitting.
NOT JOIN Transmitter has backed off and is in between
discovery attempts.
DISCOVER Transmitter has not made a connection to a
FDAP and is in discovery (searching for a
connection to a FDAP). Transmitter will
automatically enter a power saving mode if it
cannot make a connection and will retry later.
SECURING Transmitter has connected with the network
and is validating its key.
JOINING Transmitter has validated its key and is now
negotiating the parameters of the wireless
connection.
JOINED Transmitter has validated the key and has
made a secure connection with at least two
FDAP(s). Transmitter should appear in
OneWireless UI as an uncommissioned
device.
20 XYR 6000 ISA100.11a Compliant Universal I/O Transmitter User's Manual
Table 3 Transmitter connection status
What to do
Transmit a key to the transmitter. See page
29.
If Transmitter does not join the network
within five minutes, do the following:
 Check that Key is correct for the network
you are trying to join.
Check that the FDAP(s) in the local area

are turned on and are already a secure
part of the network.
 Check the Event Log to see if the
Transmitter is actively trying to join.
Errors in the Event Log show that the
Transmitter is trying to join but that there
are problems. Consult the OneWireless
UI documentation for troubleshooting
errors.
Wait for connection. If Transmitter does not
make a connection within five minutes, see
NOT CONN in this table.
Wait for connection. If Transmitter does not
make a connection within five minutes, see
NOT CONN in this table.
Wait for transmitter to move to JOINED
state. If this does not occur within five
minutes, then it may mean that the wireless
network does not have enough resources to
allow the transmitter to join. Consult
OneWireless UI documentation for
troubleshooting.
No action required.
Revision 1
January 2011