IKUSI T70/1 Operation & Installation Manual page 72

JUMPERS CONFIGURATION
Size ¼ of LR72
Connections with the LR72
TM70Bi V3.2 (11/02) 1121174 L0.pdf
IKUSI reserves the right to change this information without prior notice.
P5: "Jumper" for configuration of the
CAN direction of the expansion.
"Jumper" = ON  "1" logic.
Programmable addresses: 1...63
max
P6: "Jumper" to enable or disable the
Tele-Alignment process.
Enabled Tele-Alignment = "jumper"
placed or ON.
P6
Disabled Tele-Alignment = "jumper"
eliminated or OFF.
P6
1 = VPP (channel power)
2 = GND (Channel ground)
3 = VO (DIRECT analogue PWM output)
4 = VR (INVERSE analogue PWM output)
68