IKUSI T70/1 Operation & Installation Manual page 20

ANNEX B.- PROGRAMMING THE MACHINE IDENTIFICATION IN LCD TRANSMITTERS.
Transmitters with the LCD display option allow the operator to programme a machine identification label
of up to 24 text characters. This identification is displayed on transmitter starting-up.
This text must identify the machine with a name that is commonly known by the workmen. When first
starting the transmitter you can edit/introduce this text as follows:
1. Introduce a battery and turn the ON/OFF key to
ON.
2. Push in and then extract the STOP button and
you will observe the LED pulse orange-green.
3. Press pushbutton 4 followed by START button
and keep both pressed together during 3-4
seconds and then you will enter the "CONFIG
MODE". Press pushbutton 4. (press TWICE
pushbutton 4 if it only appears the option
"CONFIG MODE").
4. Move through the menu with pushbuttons 1 and 2
until reaching the EDIT LABEL menu. Press push
button 4.
5. Once you have entered into EDITING mode, there
appears in the display the text "CRANE ??" in
which the first character blinks. From this point
you can edit the name of the machine by means
of the push buttons 1 to 4, whose functions are
described as follows:
 Pushbutton 1:
 Pushbutton 2:
 Pushbutton 3:
 Pushbutton 4:
following one, (towards the right hand)
6. Push START to store the edited text. LCD will show the message "SAVED" for 2 seconds.
7. You exit the EDITING mode by pressing the STOP.
TM70Bi V3.2 (11/02) 1121174 L0.pdf
IKUSI reserves the right to change this information without prior notice.
To move for the list of established characters in descending order.
To move for the list of characters established in ascending order.
To return to the previous character in the display.
To validate the published
LCD
LCD
character and move to the
16