IKUSI T70/1 Operation & Installation Manual page 11

5.2.- RECEIVER
Make sure that the crane is stopped for the entire duration of the assembly process,
keep the work area free and wear protective clothing.
Park the crane and position stop-ends (if these are not available use appropriate
signs) at a suitable distance so that other cranes on the same runway do not hit it.
Check the power-supply voltage and turn off the mains switch, disconnecting the
wiring and connector between the receiver and the electrical cabinet of the machine.
Remember that the receiver has several voltage-powered circuits. Even when the
power has been cut off, there is still a risk of electrical shocks.
Find a suitable location for the receiver with easy access, in a place designated for reception of the radio
transmitter signal, and away from any intense radio electric disturbance sources.
Install the receiver cabinet using 4 elastic absorbers.
Figure 3. Receiver, external antenna and cable extension cables kit.
If necessary, it is possible to improve signal reception, by using the extension cables and external antenna kit.
This kit is applicable only for non-transmitting receivers.
TM70Bi V3.2 (11/02) 1121174 L0.pdf
IKUSI reserves the right to change this information without prior notice.
7