IKUSI T70/1 Operation & Installation Manual page 67

ANALOGUE OUTPUT
The analogue output is connected through RL2 connector with the following signals (Imax=15mA):
Pin Name
1 VOUT
2 GND
3 -V
4 +V
TELE-TEACHING (V3.1 OF SOFTWARE OR HIGHER VERSIONS)
Through Tele-Alignment can set the maximum and minimum values, the polarity inversion, acceleration or
deceleration ramp and curve type of the analogue output. To change to Tele-Alignment mode is necessary to
introduce a bridge in the jumper P5 (see Jumpers configuration). Only available for TM70 consol box from
3.1 software version or higher.
TM70Bi V3.2 (11/02) 1121174 L0.pdf
IKUSI reserves the right to change this information without prior notice.
Function
Analogue Output
Potentiometer's middle point
Negative power supply (Minimun: -50V)
Positive power supply (Maximun: 50V)
VI GN
CAN
CAN
+
Relay outputs
CAN
TELEALIGNMENT
Analogue
63