IKUSI T70/1 Operation & Installation Manual page 17

7.3 - TROUBLESHOOTING
The transmitter and receiver have status monitoring LED's, which help to identify irregularities.
The most common signals are contained in the tables below:
TRANSMITTER
LED
Solid green
Green pulses.
Red slow flashing
Red fast flashing
Red double flashing
Solid red
RECEIVER
In OPERATION mode the 7 LED's must be lit as has been previously described in section 4.3
Starting. If this is so, press the transmitter manoeuvre buttons and observe the response of the
output relays. If the response is normal, the problem is not related to the remote control
equipment and the installation must be checked. If any of the relays is not activated, the problem
is associated with the remote control equipment. If this happens, observe the appearance of the
LED's:
LED
POWER
HARDOK
SIGNAL
DATA
ID
ORDER
RELAY
There are also two LEDs in the receiver (only available in LR72 electronic card) which informa
about the status of the CAN-BUS. If the CAN connection is not working, check the status of the
LEDs:
TM70Bi V3.2 (11/02) 1121174 L0.pdf
IKUSI reserves the right to change this information without prior notice.
Transmitter transmitting normally. OPERATION mode.
Transmitter ready for start-up. STAND BY mode.
Battery level low
Probably, EEPROM module is not plugged in.
Transmitter cannot start up because a manoeuvre command is
present.
Transmitter failure
LIT
Power Supply OK
Slow: fault in the board
Board OK
Fast: error in EEPROM
RF signal OK RF signal detection in
SCANNING mode
-- Is receiving the correct data
from a TM70
-- ID Code OK
Any digital --
manoeuvre ON
STOP relays ON --
MEANS
FLASHING
-- Power Supply not OK
Fault in the board
The receiver is not receiving
RF signals
Signal received is not
correct
ID not recognised
No digital manoeuvre ON
STOP relays OFF
OFF
13