IKUSI T70/1 Operation & Installation Manual page 18

LED
CAN_RUN
CAN_ERR
If the problem is associated with the equipment, please send both the transmitter and the
receiver to the your Technical Assistance Service Agent, together with a description of the
problem and the status of the LED's.
If the transmitter becomes so damaged that a spare has to be arranged, it can be quickly
substituted by following the instructions in ANNEX A.
Display error messages V 2.4:
Error message
"Tilt switch "
"Out of Range"
"Wrong Crane "
"Error EEP"
"Error Wrong
EEP"
"Error Copy
FLASH"
"Error Open File"
"Error File Write"
"Error File Close"
"Error Open
Radio"
"Error Write
Radio"
"Error OP &
Masc"
"Error Bad data
EEP"
"Error LAL not
open"
"Error Read LAL
err"
TM70Bi V3.2 (11/02) 1121174 L0.pdf
IKUSI reserves the right to change this information without prior notice.
LIT
Operating status
Communication OK
Cause
Inclinometer detected due to an incorrect position of the
transmitter
Transmitter out of range
Crane selector is in wrong position after a crane has been
selected previously
Error when trying to access the content of the EEPROM or the
internal memory. The content of the EEPROM cannot be copied
into the internal memory
EEPROM data corrupted
When duplicating EEPPROM modules a copy failure occured
during the new EEPROM updating process
Internal memory access failure
Error when writing EEPROM data into the flash memory or
timeout error occured when trying to access to the memory
Error when trying to close the internal memory access
The radio cannot be opened
Data cannot be written in the radio
When releasing the STOP pushbutton the signals and the masks
do not match indicating that some masked order is still activated.
EEPROM data corrupted
Error when trying to open the range limiter
Range limiter data cannot be read
FLASHING
Pre-operating status
Communication error
OFF
CAN communication non
active
CAN controller disconnected
14