IKUSI T70/1 Operation & Installation Manual page 19

ANNEX A - PROGRAMMING A SPARE TRANSMITTER.
In case of damage to the transmitter, it is quickly possible to restore
service, if a spare transmitter is available. To achieve this we have to
install into the spare transmitter the exact parameters of that to be
replaced.
These parameters are stored in an EEPROM memory module, EP70,
easily accessible from the exterior of the transmitter. Switch off the
damaged transmitter and extract the EP70 module by unloosening the
two screws, as shown, and then incorporate this module into the spare
transmitter.
In cases where the damage to the transmitter prevents removal of the
EP70 module, the spare transmitter can be programmed with the
memory module EP70 found inside the receiver.
To achieve this, proceed as follows:
1.
Being the spare transmitter off, remove its empty EP70 module as described above, and insert
the EP70 module from the receiver.
2. Introduce a charged battery, turn on the
ON/OFF key, push and extract the STOP
button. The LED will pulse green for around
15 seconds.
3. To copy its contents into the internal memory
of the transmitter press pushbutton 6 followed
by START, keeping both buttons pressed
together while LED blinks red. Once the LED
start to blink orange, release the pushbuttons
and LED will lit green. In the LCD display
models the words "Reading..." and "Reading
ok Change EEP" will be indicated. In case the
LED remains in red colour, (or the LCD
displays "Reading nok"), repeat the process.
4.
When the copying process has completed,
extract the EP70 and replace it into the
receiver. Insert the empty EP70 into the
spare transmitter and again press pushbutton 6. The LED will flash orange, which indicates that
the empty EP70 is being written with the stored parameters In the LCD display models the words
"Writing..." and "Writing ok" will be indicated. In case the LED remains in red colour, (or the LCD
displays "Writing nok"), repeat the process.
5. Afterwards press the STOP. This completes the programming processes.
TM70Bi V3.2 (11/02) 1121174 L0.pdf
IKUSI reserves the right to change this information without prior notice.
15