Advertisement
D
9 B
Hughes Network Systems, LLC, of 9605 Scranton Road, San Diego, CA, 92121, USA, declares under our sole
responsibility that the Hughes 9300 Series Satellite IP Terminals to which this declaration relates, are in
conformity with the following standards and/or other normative documents:
ETSI EN 301 444, ETSI EN 300 328, ETSI EN 301 489-1, ETSI EN 301 489-17, ETSI EN 301 489-20, EN 62311,
EN 60950-1.
We hereby declare that all essential radio test suites have been carried out and that the above named product is in
conformity to all the essential requirements of R&TTE Directive 1999/5/EC.
The conformity assessment procedure referred to in Article 10 and detailed in Annex [III] or [IV] of Directive
1999/5/EC has been followed with the involvement of the following Notified Body(ies):
AmericanTCB, Inc. 6731 Whittier Avenue, Suite C110 McLean, VA 22101
Identification mark: 1588 (Notified Body number).
The technical documentation relevant to the above equipment will be held at:
•
Hughes Network Systems, LLC, 9605 Scranton Road, San Diego, CA, 92121, USA
•
Signed by Nigel Bartlett (Senior Technical Director, September, 2009) and Bill Lindsay (Senior Program
Manager, September, 2009)
The Ethernet cable used with the Hughes 9300 Series terminals shall not be longer than 3 meters
to comply with ETSI emissions requirements.
Note
F CC C
OMPLIANCE
4 1 B
•
This device conforms to the FCC rules. Any changes or modifications to Hughes Network Systems'
equipment, not expressly approved by Hughes Network Systems, could void the user's authority to
operate the equipment.
•
To comply with FCC RF exposure requirements, this device must be operated with a minimum
separation distance of 20 cm or more from a person's body. Other operating configurations should be
avoided.
•
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions;
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
J
R
APANESE
ADIO
4 2 B
C
ERTIFICATION
The 9350 Class 10 has been certified for use in Japan but requires an additional step before the terminal can be
legally used in that country. Contact JSAT Mobile before attempting to use a terminal in Japan:
Stuart Lester
JSAT Mobile Communications
Kamiyacho Sankei Building 7F, Azabudai 1-7-2 Minato-ku,
Tokyo 106-0041 Japan
TEL: +81 (0)3-6459-1167
38
ECLARATION OF CONFORMITY
L
"T
AW
ECHNICAL
" (GITEKI)
R
C
EGULATION
ONFORMITY
Hughes 9350 BGAN Terminal User Guide
Advertisement
