Advertisement
S
P
ETUP
AGE
2 6 B
The Setup page allows the User to configure various parameters of the UT. A description of each item on the
page follows:
1.
Terminal Local IP Address: This allows the user to change the local IP address of the terminal from the
default 192.168.128.100 IP address. Only the last two octets are available to change. Once the local IP
address is changed on this page and applied, the IP address ranges for the DHCP server; the PDP Context
page and ACA page will also be changed automatically. Note: Updates to this field will not take effect until
the UT is rebooted.
2.
DHCP Server: allows the DHCP server in the UT to be turned on or off
3.
DHCP Address Range: This allows the user to set the range of DHCP addresses that are given out by the
UT to any connected TE.
4.
Idle-mode DHCP Lease Time: Idle-mode DHCP lease time refers to the DHCP lease time when the UT
is not connected to the network. This parameter allows the user to change the default time (60 seconds) that
the DHCP lease to the TE is good for. This parameter was introduced because of a problem with some
models of Cisco routers that will not accept a short DHCP lease time. Note: The longer the Idle-mode
12
Hughes 9350 BGAN Terminal User Guide
Advertisement
