Operating Heater - Procom QL300RYLA Owner's Operation And Installation Manual

OPERATING
FOR YOUR SAFETY
READ BEFORE LIGHTING
If you do not
WARNING:
follow these instructions exactly, a
fire or explosion may result causing
property damage, personal injury or
loss of life.
A. This appliance has a pilot which
must be lighted by control system,
When lighting the pilot, follow
t h e s e i n s t r u c t i o n s
B. BEFORE LIGHTING smell all
around the appliance area for
gas. Be sure to smell next to the
floor because some gas is
heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
SEE WARNING in Page 1 for proper
instructiors.
C. Use only your hand to push in
control knob. Never use tools. If the
the appli ance could not operate , don't
try to repair it, Call a qualified service
technician or gas supplier.Forced or at-
tempted re-pair may result in a fire or
explosion.
D. Do not use this appliance if any
part has been under water. Imme-
diately call a qualified service techni-
cian to inspect the appliance and to
replace any part of the control system
and any gas control which has been
under water.
TO TURN OFF GAS TO APPLIANCE
Shut off heater
1. Press the IGN/OFF button of
transmitter.
2.Set the Switch on OFF location.(See
Figure12-2)
Shutting off burner only( pilot stay lit)
1.press the BURNER to set flame OFF
select
HEATER
Figure 12-1 Emergency Button
e x a c t l y .
location
If you didn't receive or mis-place your
remote transimitter,you can press the
emergency button by a pitch rod to
operate remote automatically on or off
(see fig 12-2)
Figure 12-2 On/Off Switch
1 1
OPERATING INSTRUTION OF
REMOTE-CONTROLLED BUNER
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information,
page 2.
2. Make sure equipment shutoff
valve is fully open.
NOTICE: During initial opera-
fireplace
tion of new , burning logs
will give off a paper-burning smell.
Orange flame will also be present.
Open a window to vent smell. This
will only last a few hours.
CAUTION: Do not try to adjust
heating levels by
equipment shutoff valve.
Fig 13 Front of the Transmitter
using the