Printronix T5000R Series Programmer's Reference Manual page 71

X'023601' Invalid or Unsupported Load Copy Control Simplex/Duplex
Parameter
Explanation: The LCC command simplex/duplex parameter is invalid or
unsupported.
Alternate Exception Action: If invalid, none. If unsupported, the printer
prints simplex.
X'023F02' Font Index Not Loaded
Explanation:
1. The font inline sequence in Load Font Equivalence command is not
supported or not supported with the current Text Orientation.
2. The Font Index specified in a Load Font Equivalence command called out
by a Set Coded Font Local text control is not loaded.
Alternate Exception Action: None.
X'024201' WIC Pel Count < Minimum Required
Explanation: The Target or Source Pel Count value on the Write Image
Control command is less than 1.
Alternate Exception Action: None.
X'024301' WIC Pel Count > Maximum Allowed
Explanation: The Target or Source Pel Count value on the Write Image
Control command is greater than the valid or supported maximum.
Alternate Exception Action: None.
X'024401' WIC Scan Count < Minimum Required
Explanation: The Target or Source Scan Count value on the Write Image
Control command is less than 1.
Alternate Exception Action: None.
X'024501' WIC Scan Count > Maximum Allowed
Explanation: The Target or Source Scan Count value on the Write Image
Control command is greater than the valid or supported maximum.
Alternate Exception Action: None.
Specification Check-General — X'02'
69