Printronix T5000R Series Programmer's Reference Manual page 58

Appendix B
X'030003' Incorrect Drawing Order Length
Explanation: A drawing order length is invalid.
Alternate Exception Action: None.
X'030004' Invalid Attribute Value
Explanation: An attribute value for a graphic order or for a WGC Set Current
Default instruction is invalid.
Alternate Exception Action: Use the standard default value for that
attribute.
X'030008' Truncated Order Error
Explanation: An order has been requested that is not a complete order. This
order is one of the following:
1. A fixed 2-byte order and the second byte is not in the segment.
2. A long order and the length byte is not in the segment.
3. A long order and the number of bytes following the byte containing the
length count to the end of the segment is less than the value of the length
count.
Alternate Exception Action: None.
X'03000C' Segment Prologue Error
Explanation: A supported order that is not valid within a prologue was found
in a prologue. The end of a segment was reached without an End Prologue
order.
Alternate Exception Action: None.
X'03000E' Unsupported Attribute Value
Explanation: An attribute value for a graphic order or for a WGC Set Current
Default instruction is not supported.
Alternate Exception Action: Use the standard default value for that
attribute.
56