Fitting The Threaded Bushes For The Rotary Spit - Siemens HY738357M Instruction Manual

Fitting the threaded bushes for the rotary
spit
From above, place the threaded bushes into the
1.
holes at the four corners of the universal pan.
Counter the ring nuts from below.
2.
Use a screwdriver to tighten the threaded bushes.
3.
Fitting the telescopic shelf set
Instructions on fitting the telescopic shelf set are
enclosed with the set.
1Operating the appliance
You have already learnt about the controls and how
p l i a n c e O p e r a t i n g t h e a p
they work. Now we will explain how to set your
appliance. You will learn about what happens when you
switch the appliance on and off, and how to select the
operating mode.
Hob
Switching the hob on and off
You can switch the hotplate on and off with the control
knobs.
Setting a hotplate
You can set the heat setting for the hotplates using the
hotplate control knobs. Press the control knob for the
required hotplate and turn it to the required heat setting.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
Hotplate temperature is regulated by the heat
Note:
switching on and off. The heat may also switch on and
off at the highest setting.
Large dual-circuit hotplate and extended cooking
zone
The size of these hotplates can be altered.
Switching on the large area
Turn the hotplate control to position 9 - where you will
feel a slight resistance - then continue turning to the õ/
ç symbol = large dual-circuit hotplate or extended
cooking zone
Then immediately turn it back to the desired heat
setting.
Switching back to the small area
Turn the hotplate control to 0 and reset.
The small dual-circuit hotplate is particularly good for
heating small amounts.
Caution!
Never turn the hotplate control beyond the õ/ç symbol
to 0.
Operating the appliance
en
13