Spanning-Tree Configuration Guidelines - Cisco Catalyst 3550 series Software Configuration Manual

Configuring Spanning-Tree Features
Table 16-3 Default Spanning-Tree Configuration (continued)
Feature
Spanning-tree VLAN port cost (configurable on a per-VLAN basis)
Spanning-tree timers

Spanning-Tree Configuration Guidelines

If more VLANs are defined in the VTP than there are spanning-tree instances, you can enable PVST+
or rapid PVST+ on only 128 VLANs. The remaining VLANs operate with spanning tree disabled. If the
number of VLANs exceeds 128, we recommend that you enable the MSTP to map multiple VLANs to
a single spanning-tree instance. For more information, see the
For information on the recommended trunk port configuration, see
section on page
If 128 instances of spanning tree are already in use, you can disable spanning tree on one of the VLANs
and then enable it on the VLAN where you want it to run. Use the no spanning-tree vlan vlan-id global
configuration command to disable spanning tree on a specific VLAN, and use the spanning-tree vlan
vlan-id global configuration command to enable spanning tree on the desired VLAN.
Caution Switches that are not running spanning tree still forward BPDUs that they receive so that the other
switches on the VLAN that have a running spanning-tree instance can break loops. Therefore, spanning
tree must be running on enough switches to break all the loops in the network; for example, at least one
switch on each loop in the VLAN must be running spanning tree. It is not absolutely necessary to run
spanning tree on all switches in the VLAN; however, if you are running spanning tree only on a minimal
set of switches, an incautious change to the network that introduces another loop into the VLAN can
result in a broadcast storm.
If you have already used all available spanning-tree instances on your switch, adding another VLAN
Note
anywhere in the VTP domain creates a VLAN that is not running spanning tree on that switch. If you
have the default allowed list on the trunk ports of that switch, the new VLAN is carried on all trunk ports.
Depending on the topology of the network, this could create a loop in the new VLAN that will not be
broken, particularly if there are several adjacent switches that have all run out of spanning-tree instances.
You can prevent this possibility by setting up allowed lists on the trunk ports of switches that have used
up their allocation of spanning-tree instances. Setting up allowed lists is not necessary in many cases and
can make it more labor-intensive to add another VLAN to the network.
Spanning-tree commands determine the configuration of VLAN spanning-tree instances. You create a
spanning-tree instance when you assign an interface to a VLAN. The spanning-tree instance is removed
when the last interface is moved to another VLAN. You can configure switch and port parameters before
a spanning-tree instance is created; these parameters are applied when the spanning-tree instance is
created.
Catalyst 3550 Multilayer Switch Software Configuration Guide
16-12
12-19.
Chapter 16
Default Setting
1000 Mbps: 4.
100 Mbps: 19.
10 Mbps: 100.
Hello time: 2 seconds.
Forward-delay time: 15 seconds.
Maximum-aging time: 20 seconds.
Chapter 17, "Configuring MSTP."
the"Interaction with Other Features"
Configuring STP
78-11194-09