Displaying Span And Rspan Status - Cisco Catalyst 3550 series Software Configuration Manual

Chapter 24 Configuring SPAN and RSPAN

Displaying SPAN and RSPAN Status

To display the status of the current SPAN or RSPAN configuration, use the show monitor privileged
EXEC command.
This is an example of output for the show monitor privileged EXEC command for SPAN source
session 1:
Switch# show monitor session 1
Session 1
---------
Type
Source Ports
Source VLANs
Source RSPAN VLAN : None
Destination Ports : Fa0/5
Reflector Port
Filter VLANs
Dest RSPAN VLAN
78-11194-09
: Local Session
:
RX Only : None
TX Only : None
Both : Fa0/4
:
RX Only : None
TX Only : None
Both : None
Encapsulation: DOT1Q
Ingress: Enabled, default VLAN = 5
: None
: None
: None
Catalyst 3550 Multilayer Switch Software Configuration Guide
Displaying SPAN and RSPAN Status
24-23