Default Ospf Configuration - Cisco Catalyst 3550 series Software Configuration Manual

Configuring OSPF

Default OSPF Configuration

Table 31-7
Table 31-7 Default OSPF Configuration
Feature
Interface parameters
Area
Auto cost
Default-information originate
Default metric
Distance OSPF
OSPF database filter
IP OSPF name lookup
Log adjacency changes
Neighbor
Neighbor database filter
Network area
Router ID
Summary address
Timers LSA group pacing
Catalyst 3550 Multilayer Switch Software Configuration Guide
31-30
shows the default OSPF configuration.
Default Setting
Cost: No default cost predefined.
Retransmit interval: 5 seconds.
Transmit delay: 1 second.
Priority: 1.
Hello interval: 10 seconds.
Dead interval: 4 times the hello interval.
No authentication.
No password specified.
MD5 authentication disabled.
Authentication type: 0 (no authentication).
Default cost: 1.
Range: Disabled.
Stub: No stub area defined.
NSSA: No NSSA area defined.
100 Mbps.
Disabled. When enabled, the default metric setting is 10, and the
external route type default is Type 2.
Built-in, automatic metric translation, as appropriate for each
routing protocol.
dist1 (all routes within an area): 110.
dist2 (all routes from one area to another): 110.
and dist3 (routes from other routing domains): 110.
Disabled. All outgoing link-state advertisements (LSAs) are
flooded to the interface.
Disabled.
Enabled.
None specified.
Disabled. All outgoing LSAs are flooded to the neighbor.
Disabled.
No OSPF routing process defined.
Disabled.
240 seconds.
Chapter 31 Configuring IP Unicast Routing
78-11194-09