Cisco Catalyst 3550 series Software Configuration Manual page 623

Chapter 29 Configuring QoS
Beginning in privileged EXEC mode, follow these steps to create an IP extended ACL for IP traffic:
Command
Step 1
configure terminal
Step 2
mls qos
Step 3
access-list access-list-number {deny |
permit} protocol source source-wildcard
destination destination-wildcard
Step 4 end
Step 5
show access-lists
Step 6 copy running-config startup-config
To delete an access list, use the no access-list access-list-number global configuration command.
This example shows how to create an ACL that permits IP traffic with a DSCP value set to 32 from any
source to any destination:
Switch(config)# access-list 100 permit ip any any dscp 32
This example shows how to create an ACL that permits IP traffic with a precedence value of 5 from a
source host at 10.1.1.1 to a destination host at 10.1.1.2:
Switch(config)# access-list 100 permit ip host 10.1.1.1 host 10.1.1.2 precedence 5
78-11194-09
Purpose
Enter global configuration mode.
Enable QoS on the switch.
Create an IP extended ACL, repeating the command as many times as
necessary.
For access-list-number, enter the access list number. The range is
•
100 to 199 and 2000 to 2699.
• Use the permit keyword to permit a certain type of traffic if the
conditions are matched. Use the deny keyword to deny a certain
type of traffic if conditions are matched.
• For protocol, enter the name or number of an IP protocol. Use the
question mark (?) to see a list of available protocol keywords.
• For source, enter the network or host from which the packet is
being sent. You specify this by using dotted decimal notation, by
using the any keyword as an abbreviation for source 0.0.0.0
source-wildcard 255.255.255.255, or by using the host keyword
for source 0.0.0.0.
For source-wildcard, enter the wildcard bits by placing ones in the
•
bit positions that you want to ignore. You specify the wildcard by
using dotted decimal notation, by using the any keyword as an
abbreviation for source 0.0.0.0 source-wildcard 255.255.255.255,
or by using the host keyword for source 0.0.0.0.
• For destination, enter the network or host to which the packet is
being sent. You have the same options for specifying the
destination and destination-wildcard as those described by source
and source-wildcard.
Note When creating an access list, remember that, by default, the end
of the access list contains an implicit deny statement for
everything if it did not find a match before reaching the end.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Catalyst 3550 Multilayer Switch Software Configuration Guide
Configuring Standard QoS
29-37