Character Sets - Printek FormsPro 4300 Owner's Manual

IBM Proprinter Emulation

Character Sets

Select Character Set 1
Selects character set 1. Disables printing of character values 0 through 31 decimal,
and 128 through 159 decimal, so these characters will be treated as control codes.
Overrides the "Chars:" value in the "Setup: INTERFACE" menu.
Escape Sequence:
Hexadecimal:
Select Character Set 2
Selects character set 2. Enables printing of character values 0 through 31 decimal if
they are not used as control codes. Enables printing of character values 128 through
159 decimal, so these characters will not be treated as control codes. Overrides the
"Chars:" value in the "Setup: INTERFACE" menu.
Escape Sequence:
Hexadecimal:
Print Single Character
Prints the character n from the all characters chart. This sequence may be used to
print a character that is normally treated as a control code.
Example: The following escape sequence will print a left arrow. This character is
normally not printable, since it is treated as the ESC control code.
Escape Sequence:
Hexadecimal:
Print Characters
Prints the next n1 + (n2 x 256) characters from the all characters chart. This sequence
may be used to print characters that are normally treated as a control codes.
Example: The following escape sequence will print an up arrow, a down arrow, a
right arrow, and a left arrow.
Escape Sequence:
Hexadecimal:
Page 4-8
ESC 7
1B 37
ESC 6
1B 36
ESC ^ ESC
1B 5E 1B
ESC \ 4 0
1B 5C 04 00
CAN EM SUB ESC
18 19 1A 1B
ESC 7
ESC 6
ESC ^ n
ESC \ n1 n2