Character Size And Line Spacing - Printek FormsPro 4300 Owner's Manual

ANSI X3.64 Emulation

Character Size and Line Spacing

Set Character and Line Spacing
Sets the character and line spacing in decipoints (1/720 of an inch). The first
parameter, n1, sets the line spacing. The second parameter, n2, sets the character
spacing. Typical values for n1 and supported values for n2 are shown below. Other
values for n2 will be ignored. To change only the horizontal or only the vertical
spacing, omit the other value from the sequence or set it to zero. Overrides the "CPI:"
value and the "LPI:" value in the "Setup: FORM" menu.
n1
120
90
n2
72
60
54
48
43
42
36
Example: The following escape sequence will select 6 lpi and 10 cpi.
Escape Sequence:
Hexadecimal:
Example: The following escape sequence will select 6 lpi without affecting character
spacing.
Escape Sequence:
Hexadecimal:
Example: The following escape sequence will select 10 cpi without affecting line
spacing.
Escape Sequence:
Hexadecimal:
Page 2-4
line pitch
6 lpi
8 lpi
character pitch
10 cpi
12 cpi
13.3 cpi
15 cpi
16.74 cpi
17.14 cpi
20 cpi
ESC [ 1
1B 5B 31
ESC [ 1
1B 5B 31
ESC [ ;
1B 5B 3B
ESC [ n1 ; n2 SP G
2 0 ; 7
32 30 3B 37
2 0 SP G
32 30 20 47
7 2 SP G
37 32 20 47
2 SP G
32 20 47