Character Size - Printek FormsPro 4300 Owner's Manual

Printek Emulation

Character Size

Set Character Spacing
Sets character spacing in decipoints (n/720 of an inch). Overrides the "CPI:" value in
the "Setup: FORM" menu. Supported values are shown in the following table.
n
72
60
54
48
43
42
36
Example: The following escape sequence will select 10 cpi character spacing.
Escape Sequence:
Hexadecimal:
Double-Wide Mode
Selects double-wide mode for n=1, or cancels for n=0. Double-wide mode doubles
the width of all characters, but does not affect character height. ESC S 3 may be used
to select double-high mode.
Example: The following escape sequence will select double-wide mode.
Escape Sequence:
Hexadecimal:
Select Script Modes
Selects normal character height for n=0, subscript mode for n=1, superscript mode for
n=2, or double-high mode for n=3. This is shown in the following table.
n
0
1
2
3
Subscript mode will print characters about half the normal height in the bottom half
of the normal character cell. Superscript mode will print characters about half the
normal height in the top half of the normal character cell. Double-high mode doubles
Page 7-4
Character Size
10 cpi
12 cpi
13.3 cpi
15 cpi
16.74 cpi
17.14 cpi
20 cpi
ESC SP 72
1B 20 48
ESC W 1
1B 57 31
Script Mode
Script modes off
Subscript
Superscript
Double high
ESC SP n
ESC W n
ESC S n