Printek FORMSMASTER 8000SE Operator's Manual page 74

P R I N T E R
This item sets the Imager or ImagerPlus emulation mode. QMS CodeV
v2 selects QMS Code V version 2, PTX CodeV v2 selects Printronix
Code V version 2.
Control Character
Possible Values: ^ (5E Hex)*
This item sets the control character used to begin commands.
character normally used for QMS is the caret (^) and the character nomally
used for IGP is the tilde (~) (if you change the emulation to Printronix
IGP, you may need to change the control character to the tilde).
Line Terminator
Possible Values:
This item sets the line terminating character to a Line Feed or a Carriage
Return.
Bar Code Density
Possible Values: Low-Res, Medium-Res, High-Res*,
This item sets the density, or graphics resolution, for bar codes.
QMS Character Set
(QMS CodeV v2 and PTX CodeV v2 only)
66
C O N F I G U R A T I O N
SOH (01 Hex) through HT (09 Hex),
SO (0E Hex) through (FF Hex)
LF*, CR
Graphics Med-Res
ControlCharact
^ (5E Hex)
Terminator
Bar Code
Density
High-Res
QMS Char Set
er
The
Line
LF
USA