Printek FORMSMASTER 8000SE Operator's Manual page 100

U S I N G T H E
installation is complete and the printer will continue with its normal
power up procedure.
Initializing
Setup Module
7. The printer will now compare the configuration data in its internal
memory to the data in the Setup Module. If the data are not an exact
match, the printer will proceed with step 8.
If the data in the printer and the data in the module are an exact
match, installation is complete and the printer will complete its power
up procedure.
8. The printer has now determined that the data in the Setup Module
does not exactly match the data in the printer's internal memory. The
printer will now display the following message, the ONLINE indicator
will flash yellow and the bell will beep to get the operator's attention.
Proceed to step 9.
New Setup
Detected
9. Press the ONLINE button. The printer will now stop flashing the
ONLINE indicator (will remain yellow) and display the following
message. You must now make one of the selections as described
below.
Copy to
Printer
Copy to
Module
If you wish to copy the Setup data to the printer from the Setup
Module, press the button indicated by the arrow next to
Printer
92
O P T I O N A L
Module
(the SETUP button). The printer will display the following
S E T U P M O D U L E
Copy to