Aligning Print - Printek FORMSMASTER 8000SE Operator's Manual

D A I L Y O P E R A T I O N

Aligning Print

When a new form is loaded into the printer for the first time, it may be
necessary to adjust where printing begins. This depends upon how the
software that controls the printing was written. If the software was written
to perform its own character and line spacing relative to the edges of the
form, then adjustment may not be necessary. If the print position needs to
be adjusted, the following discussion will describe how this is accomplished.
Note that the alignment for the selected form is permanently stored in the
printer's memory and does not have to be readjusted each time the form is
loaded.
To align print on a particular form, select that form with the FORM SELECT
button and then press the ALIGN PRINT button. If the form selected is
named "Invoices", the display would now show the following.
Aligning Print
On INVOICES
After a short time, the display would change to show that you can now
MOVE PRINT left or right. Be sure to remember that you are moving
where the print is placed on the page.
Left/Right
The VALUE buttons will move the print left or right in 1/100
increments. Note that the left and right arrows will change according to
which way the print has been moved from the normal print position. The
maximum distance print may be moved is 9.99 inches in either direction.
To move the print vertically on the page, press either of the ITEM buttons
and the display will change to the following.
36
MOVE
PRINT
0.00"
th
inch