Using The Item And Value Buttons; Exiting Setup - Printek FORMSMASTER 8000SE Operator's Manual

select which form (Form 0 through Form 9) is to be set up. Note that
not all menus have submenus. If no submenu is available, the bottom line
will be blank and the SUBMENU button will not be used.

Using the ITEM and VALUE Buttons

Once the correct menu and submenu (if available) is selected, pressing
either of the ITEM buttons will cause the various items and their current
values to be displayed. Note that the items and their values are right
justified and are thus controlled by the buttons to the right of the display.
To scroll through the items available, use the ITEM buttons. To change the
value of t h e displayed item, use the VALUE buttons to step through the
possible choices. Remember to leave the correct value displayed before
selecting a different item or menu, since "what you see is what you get"
when Setup Mode is exited.

Exiting Setup

Two methods of exiting Setup are available. If you wish to exit Setup and
remain off line, press the MENU button to display the following option.
No
Setup
Yes
Pressing the button indicated for No will allow you to make additional menu
choices. Pressing the button indicated for Yes will display one of the
following messages depending on whether or not changes were made, reset
the printer if changes were made, and then leave the printer off line.
Exiting Menus
Saving Changes
Exiting Menus
No Changes
P R I N T E R
Exit
Menus?
C O N F I G U R A T I O N
43