ABB i-bus KNX Product Manual page 16


ABB i-bus KNX
Device technology
Note
The DALI gateway conforms to the SELV properties to IEC 60 364 4 41 (DIN VDE 0100 410).
DALI does not need to feature SELV properties, and it is possible to route the DALI control lines
together with the mains voltage on a multi-core cable.
All-pole disconnection must be ensured in order to avoid dangerous touch voltages which originate from
feedback from differing phase conductors.
Installation must be performed so that both DALI lines and lines carrying mains voltage are
disconnected when an area is disconnected.
Device type Application
DLR/A 4.8.1.1 Control Dim Groups 4f DALI/1*
* ... = current version number of the application. Please observe the software information on our homepage for this purpose.
Note
The ETS and the current version of the device application are required for programming.
Editing parameters with ETS2 is not possible!
The current application program can be found with the respective software information for download on
the Internet at www.abb.com/knx. After import in the ETS, the application is available under
ABB/Lighting/Light Controller/Control Dim Groups 4f DALI/1.
The device does not support the locking function of a KNX device in the ETS. If you inhibit access to all
devices of the project with a BCU code, it has no effect on this device. Data can still be read and
programmed.
14 2CDC507128D0202 | DLR/A 4.8.1.1
Max. number of
Communication objects
212
Max. number of Max. number of
group addresses associations
254 255