Ipv6 Traceroute - Brocade Communications Systems ICX 7250 Series Configuration Manual

Fastiron layer 3 routing
Hide thumbs Also See for ICX 7250 Series:
Table of Contents

Advertisement

If the IPv6 address you specify is a link-local address, you must specify the outgoing-interface ethernet port | ve number parameter.
This parameter identifies the interface that must be used to reach the remote host. If you specify an Ethernet interface, you must also
specify the port number associated with the interface. If you specify a VE interface, also specify the VE number.
Establishing a Telnet session from an IPv6 host
To establish a Telnet session from an IPv6 host to the Brocade device, open your Telnet application and specify the IPv6 address of the
Layer 3 Switch.

IPv6 traceroute

NOTE
This section describes the IPv6 traceroute command. For details about IPv4 traceroute, refer to the Brocade FastIron
Monitoring Configuration Guide.
The traceroute command allows you to trace a path from the Brocade device to an IPv6 host.
The CLI displays trace route information for each hop as soon as the information is received. Traceroute requests display all responses of
a minimum TTL of 1 second and a maximum TTL of 30 seconds. In addition, if there are multiple equal-cost routes to the destination,
the Brocade device displays up to three responses.
For example, to trace the path from the Brocade device to a host with an IPv6 address of 2001:DB8:349e:a384::34, enter the following
command:
device# traceroute ipv6 2001:DB8:349e:a384::34
Syntax: traceroute ipv6 ipv6-address
The ipv6-address parameter specifies the address of a host. You must specify this address in hexadecimal using 16-bit values between
colons as documented in RFC 2373.
IPv6 Web management using HTTP and HTTPS
When you have an IPv6 management station connected to a switch with an IPv6 address applied to the management port, you can
manage the switch from a Web browser by entering one of the following in the browser address field.
http://[<ipv6 address>]
or
https://[<ipv6 address>]
NOTE
You must enclose the IPv6 address with square brackets [ ] in order for the Web browser to work.
Brocade FastIron Layer 3 Routing Configuration Guide
53-1003903-04
IPv6 management (IPv6 host support)
141

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Icx 7450 seriesIcx 7750 series

Table of Contents