FIGURE 34 Basic VRRP topology
1.
On the device designated as the owner VRRP device, from privileged EXEC mode, enter global configuration mode by issuing
the configure terminal command.
device# configure terminal
2.
Globally enable VRRP.
device(config)# router vrrp
3.
Configure the Ethernet interface link for Router 1.
device(config)# interface ethernet 1/1/6
4.
Configure the IP address of the interface.
device(config-if-e1000-1/1/6)# ip address 10.53.5.1/24
5.
Assign Router 1 to the virtual router ID (VRID) 1.
device(config-if-e1000-1/1/6)# ip vrrp vrid 1
NOTE
You can assign a VRID number in the range of 1 through 255.
Brocade FastIron Layer 3 Routing Configuration Guide
53-1003903-04
Enabling an owner VRRP device
433