Datalogic Magellan 8400 Quick Reference Manual page 13

PRESS
DURATION
Momentary
(when scanner is
in Sleep Mode)
Momentary
(when scanner is
in Normal Oper-
ating Mode)
Hold, then
release when the
beeper sounds
4 Seconds
8 Seconds
a. By standard default, this function is normally disabled to prevent accidental activation by users.
b. Users should not perform scanner resets except under the direction of trained systems support person-
nel.
Quick Reference Guide
Volume/Tone Push Button
The Volume/Tone Push Button also performs multiple functions
depending upon the duration of time it is pressed:
Table 2. Volume/Tone Push Button Functions
FUNCTION
Wakes scanner
from Sleep Mode
Increments vol-
ume
Increments tone
Scanner Diagnos-
a
tics Mode
b
Resets Scanner
Alternatively, the scanner can be awakened by:
- Moving an object through the scan zone.
- A weight change on the scale.
- Scanning with an attached auxiliary scanner.
Press the push button momentarily to increase
speaker volume. When the loudest volume is
reached, a repeated press of the push button cycles
volume back to the lowest setting, then volume
increases on subsequent press(es). Four volume
levels are available.
Press the push button for approximately 2 seconds,
then release. Each time this is done, the beeper will
sound at one of three tones. Stop when the desired
tone (high, medium or low) is sounded.
This mode allows system support personnel to
troubleshoot problems with the scanner. Generally
diagnostics are initiated after noting a Field
Replaceable Unit (FRU) Warning (see
power to exit Scanner Diagnostics Mode.
Only system support personnel should perform a
reset.
COMMENT
Table 1
). Cycle
7