Configuring The Managed Ethernet Switch Module - GE C30 Instruction Manual
Controller system
ur series
Hide thumbs
Also See for C30:
- Instruction manual (488 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (480 pages)
Table of Contents
Advertisement
3 HARDWARE
6.
Select the Settings > Product Setup > Communications > Ethernet Switch > Configure IP menu item as shown
below.
7.
Enter (or verify) the MAC Address, IP Address, Subnet Mask, and Gateway IP Address settings.
8.
Click the Save button. It will take few seconds to save the settings to the Ethernet switch module and the following
message displayed.
9.
Verify that the target message is cleared and that the C30 displays the MAC address of the Ethernet switch in the
Actual Values > Status > Ethernet Switch window.
The C30 device and the Ethernet switch module communications setup is now complete.
A suitable IP/gateway and subnet mask must be assigned to both the switch and the UR relay for correct operation. The
Switch has been shipped with a default IP address of 192.168.1.2 and a subnet mask of 255.255.255.0. Consult your net-
work administrator to determine if the default IP address, subnet mask or default gateway needs to be modified.
Do not connect to network while configuring the switch module.
CAUTION
GE Multilin
3.4 MANAGED ETHERNET SWITCH MODULES
3.4.5 CONFIGURING THE MANAGED ETHERNET SWITCH MODULE
C30 Controller System
3
3-43
Advertisement
Table of Contents
