GE C30 Instruction Manual page 131

5 SETTINGS
1. Enter the new password in the Enter New Password field.
2. Re-enter the password in the Confirm New Password field.
3. Click the Change button. This button will not be active until the new password matches the confirmation password.
4. If the original password is not "0", then enter the original password in the Enter Password field and click the Send
Password to Device button.
5. The new password is accepted and a value is assigned to the
If a command or setting password is lost (or forgotten), consult the factory with the corresponding Encrypted Password
value.
d) ACCESS SUPERVISION

PATH: SETTINGS PRODUCT SETUP
 ACCESS
 SUPERVISION
MESSAGE
MESSAGE
The following access supervision settings are available.
• INVALID ATTEMPTS BEFORE LOCKOUT: This setting specifies the number of times an incorrect password can be
entered within a three-minute time span before lockout occurs. When lockout occurs, the
REMOTE ACCESS DENIED
expiration of the lockout.
• PASSWORD LOCKOUT DURATION: This setting specifies the time that the C30 will lockout password access after
the number of invalid password entries specified by the
The C30 provides a means to raise an alarm upon failed password entry. Should password verification fail while accessing
a password-protected level of the relay (either settings or commands), the
asserted. The operand can be programmed to raise an alarm via contact outputs or communications. This feature can be
used to protect against both unauthorized and accidental access attempts.
The
UNAUTHORIZED ACCESS
command. Therefore, to apply this feature with security, the command level should be password-protected. The
ALARMS
operand does not generate events or targets.
If events or targets are required, the
with event logs or targets enabled.
GE Multilin
 
SECURITY ACCESS SUPERVISION
 ACCESS LEVEL
 TIMEOUTS
INVALID ATTEMPTS
BEFORE LOCKOUT: 3
PASSWORD LOCKOUT
DURATION: 5 min
FlexLogic™ operands are set to "On". These operands are returned to the "Off" state upon
operand is reset with the
COMMANDS
UNAUTHORIZED ACCESS
C30 Controller System
ENCRYPTED PASSWORD
Range: 2 to 5 in steps of 1
Range: 5 to 60 minutes in steps of 1
INVALID ATTEMPS BEFORE LOCKOUT
UNAUTHORIZED ACCESS

CLEAR RECORDS
operand can be assigned to a digital element programmed
5.2 PRODUCT SETUP
item.
LOCAL ACCESS DENIED
setting has occurred.
FlexLogic™ operand is

RESET UNAUTHORIZED
5-7
5
or