Grizzly H5527 Owner's Manual page 16

SECTION 6: MAINTENANCE
Cleaning
Use a good solvent to clean the nose
assembly of the nailer. Always be sure that
the nailer is dry before using it again.
Do not allow dust, chips, sand, etc. into
the air connectors or into the body of the
nailer; this may result in leaks and damage
to the nailer and the air couplings.
Never use gasoline or other flamma-
ble liquids to clean this tool. Vapors
in the tool may ignite, causing the
tool to explode. Ignoring this warning
may lead to serious personal injury or
even death!
-14
-
Lubricating
Use Grizzly Model G2820 Pneumatic Tool
Oil or any other type of pneumatic tool oil.
Place two to six drops of oil in the nailer
air inlet (as shown in Figure 11) before
every use, or after 2 hours of continuous
use. Wipe off any excess oil near the nailer
exhaust to avoid dust build-up.
Another option to manual oiling would be
to install a lubricator in your air compres-
sor line. If your air compressor line already
has a lubricator, then regular lubrication
of your nailer will not be necessary. Just
make sure there is always oil in the lubri-
cator.
Figure 11. Lubricating nailer via air inlet.
H5527 18-Gauge Brad Nailer