Table of Contents
Advertisement
Available languages
Available languages
16
3.14 FIXTURE SETTINGS
It is possible to change the parameter value in the following way:
Dimmer
• Enter in Dimmer mode to select specific dimming curve, press the button MENU so many times
until shows [DIM MODE], and press the button ENTER to confirm.
• Press the button UP/DOWN to select [Off - DIM1 - DIM2 - DIM3].
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
Temp
Show the temperature unit.
• Press the button MENU so many times until shows [TEMP]
3.15 ACTIVATE THE PASSWORD
Enter the KEY mode to select whether the access password is on or off.
• Press the button MENU so many times until show [PASS] and press the button ENTER to confirm.
• Select [ON] or [OFF].
When the fixture is set as pass [ON], after 30 seconds or turn on the fixture next time, the fixture will need
an access password to enter the display menu control.
NOTE - The factory access password is UP + DOWN + UP + DOWN. Press ENTER to confirm the access.
LUMiPiX12QiP
Advertisement
Table of Contents
