ProLights LUMIPIX 12QIP User Manual page 30

Outdoor linear colorchanger
Table of Contents

Advertisement

Available languages

Available languages

10
3.4 AUTO SHOW
This fixture has a built-in automatic program. To access this, please see the below instructions:
• Press the button MENU so many times until shows [P--], then press the button ENTER.
• Using UP/DOWN button, select one of the programs [P1 - P13].
• Press the button ENTER to confirm.
• Press the button MENU until [S--] appears on the display.
• Use the button UP/DOWN to select the auto programs speed [S001 - S100] (slow-fast).
• Press the button ENTER save the setting.
3.5 STATIC COLOR
This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
• Press the button MENU so many times until shows [C--], then press the button ENTER.
• Using UP/DOWN button, select one of the programs [C1 - C15].
• Press the button ENTER to confirm.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.6 MANUAL COLOR
This mode allows to combine the colors red, green and blue (r, g, b, W).
• Press the button MENU so many times until the display shows [U--], then press the button ENTER.
• Select the color [r, g, b,W] through the buttons UP/DOWN.
• Press the button ENTER to confirm.
• Using UP/DOWN button, select the desired color value [000 - 255].
• Press ENTER button to continue to the next color.
• Continue until the desired mix is obtained.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.7 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 12).
• Set on master fixture the desired program (see section 3.4).
• Set the slaves to the same DMX modes.
3.8 LINKING
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
3.9 DMX MODE
• Press the button MENU so many times until shows [CH4], [CH6], [CH10], [CH48] or [CH53] and press the button
ENTER to confirm.
• Press the button UP/DOWN to select the desired DMX address [d001 - d512]. Press and hold to scroll
quickly. Press ENTER button to store.
LUMiPiX12QiP

Advertisement

Table of Contents
loading

Table of Contents