Migration Has Failed With "The Specified Blade Is Busy" Message - Hitachi NVM Navigator v03-07 User Manual

Migration has failed with "The specified blade is busy" message

Event
Although there is no problem in the HVM and LPAR configuration in the source
and the destination, or successful migration of like instances in the past is
proven, a migration execution error-stopped with "The specified blade is busy"
message.
Figure 6-17 Migration Progress window
This event occurs when a process initiated by HVM Navigator conflicts with
another process initiated by the operation on HVM screen or the HVM setting
operation from SC/BSM. When executing migration of an LPAR, attention has
to be paid that the subject HVM is not being operated from SC/BSM and that
HVM screen is not in use. If a sub screen opened from HVM screen remains
open, the process of HVM screen is recognized busy. Take actions according to
the procedure in "Solution" below.
Solution
1. Confirm if HVM screen (including sub screens) is open at the source or at
the destination. If it is, wait until the ongoing operation ends or terminate
the ongoing operation, and then close HVM screen.
2. Retry the failed migration. If the same event occurs again, confirm if the
terminal software has been closed with any process initiated by HVM
screen still running (including sub screens for HVM configuration setting,
LPAR configuration setting, activation and deactivation). If that is the case,
reopen the terminal software, terminate applicable process, and retry the
failed migration again.
Troubleshooting
HVM Navigator User's Guide - Migration
6-15