Hitachi NVM Navigator v03-07 User Manual page 98

Note on selecting VNIC Device Type

CB2000
You can select VNIC Device Type when you operate HVM firmware version 59-
00/79-00 or higher. However, when you set VNIC Device Type to NIC2 on the
source HVM and you set Hvm Operating Mode to Standard on the destination
HVM, you cannot have LPARs migrate on the source HVM to the destination
HVM. Also, when you set VNIC Device Type to NIC2 on the source HVM and
NIC2 is not supported on the destination HVM, you cannot have LPARs migrate
on the source HVM to the destination HVM. For the combination of migratable
environments between the source and destination HVMs, see the following
tables.
Table 2-123 Combination of migratable environments (CB2000 standard
Source
HVM firmware version
58-8x or earlier
59-0x or earlier
-: not selectable
Table 2-124 Combination of migratable environments (CB2000 high-
Source
HVM firmware version
78-8x or earlier
79-0x or earlier
- : not selectable
2-76
server blade)
Destination
VNIC Device Type
-
NIC1
NIC2
performance server blade)
Destination
VNIC Device Type
-
NIC1
NIC2
Usage environments
HVM Navigator User's Guide - Migration
Concurrent Maintenance
HVM firmware version
58-8x or earlier
Standard/Expansion Standard
Yes
Yes
No
HVM firmware version
78-8x or earlier
Standard/Expansion Standard
Yes
Yes
No
59-0x or higher
Expansion
Yes Yes
Yes Yes
No Yes
79-0x or higher
Expansion
Yes Yes
Yes Yes
No Yes