Advertisement
Gear Position Indicator with programmable
1. Foreword
Congratulations on your purchase of a GIpro X-type gear position indicator.
The GIpro products from HealTech Electronics Ltd. are the most advanced gear
position indicators on the market today.
This GIpro model will fit all motorcycles and vehicles which have an electronic
speedometer (either analogue or digital readout).
Your speedometer is electronic if the odo/tripmeter has LCD readout.
If your speedometer is cable driven, it is still possible to install this product with
our GPX-WSS harness kit
Due to a modern microprocessor and sophisticated firmware, the GIpro-X offers
faster and more reliable readings than competing products.
The unit is also the smallest, most compact gear indicator available, making it
easy to mount at the instrument cluster.
The display is auto-learning, there are no buttons and no "programming wire".
2. Operation
Your motorcycle is not equipped with a Gear Position Sensor, therefore
determining and displaying the gear in use is only possible when the engine is
running and the clutch is fully released.
At other times (clutch pulled-in, engine not running, bike stopped) the display
will show a "-" sign.
The GIpro will NOT show an incorrect gear in any circumstances, except for a
split second when the clutch is released slowly (slipping) during a back shift.
3. Installation
The Harness Kit required for the installation is supplied separately. Along with
the Display unit, please make sure to order the correct wiring harness kit for
your bike. Please refer to the install instructions received with the Harness Kit.
GPX_UsersGuide_en.pdf
http://www.gi-pro.net
GI
pro
Shift Light and High Speed Warning
User's Guide
.
[rev. 002]
X-type
- 1 -
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Healtech GIpro X-type
Summary of Contents for Healtech GIpro X-type
- Page 1 Shift Light and High Speed Warning User’s Guide 1. Foreword Congratulations on your purchase of a GIpro X-type gear position indicator. The GIpro products from HealTech Electronics Ltd. are the most advanced gear position indicators on the market today. This GIpro model will fit all motorcycles and vehicles which have an electronic speedometer (either analogue or digital readout).
- Page 2 4. Setup You need to set up this module after installation. It is recommended to perform the setup procedure with WARM engine. - Raise rear wheel ground using stand. (If you do not have a stand, or your speedometer is driven off the front wheel, set up the unit while riding.
- Page 3 5. Reset If some gears are not indicated correctly, reset the unit and set it up again. - Have the engine stop switch in OFF position. - Turn the ignition key ON and immediately turn it off while the GIpro display is counting up and is showing “3, or 5”.
- Page 4 To ensure trouble-free operation from the start, all units have been extensively tested prior to shipment. Our dealers offer a 30-day money-back guarantee on HealTech products if the product does not fulfil your expectations. (All parts must be returned in original condition for full refund.)
- Page 5 Disclaimer: Do not attempt to install the product if you don’t have basic mechanical skills. HealTech Electronics Ltd. and its distributors shall not be liable for any loss or damage caused by improper installation. If in doubt, please consult with your dealer.
- Page 6 3. Find the RPM signal wire: CBF500, CBR250R Yellow/Green (Solid Yellow wire with thin Green stripe) Tachometer signal wire, find either at the ECU connector or at the dashboard connector. VTX1800, VT750, Yellow NRX1800, Valkyrie Rune (Solid Yellow) Crankshaft signal wire, find either at the ECU connector or at the 2-pole plug of the ignition pulse generator (pickup coil).
Need help?
Do you have a question about the GIpro X-type and is the answer not in the manual?
Questions and answers