Operation - AEMC J93 User Manual

■ Set the switch to the
indicator lights, the battery must be replaced (see §5.3).
■ Set the switch to ON. The indicator lights.
■ Connect the current probe to one of
the current inputs on the device.
■ Turn the device ON.
■ Adjust the zero by watching the
display of the device and turning the
zero adjustment knob until the device
displays 0.
■ Open the jaws and clamp the
conductor carrying the current to be
measured. There must be only one
conductor in the jaws of the clamp.
■ Gently close the jaws. In order to optimize measurement quality, center the
conductor as accurately as possible in the jaws.
■ Read the measurement on the device.
■ When the measurement is over, open the clamp and withdraw the conductor.
Then disconnect the clamp from the device.
■ Turn the device and clamp OFF.
6
Shop for AEMC products online at:

3. OPERATION

position to check the battery status. If the battery
ShopAEMC
www.
V1 V2 V3 N I1 I2 I3
1000V CAT III 600V CAT IV
POWER & ENERGY LOGGER
ON /OFF
START/STOP
AC/DC Current Probe Model J93
.com 1.877.766.5412