Important Notices - Phonak DynaMic User Manual

Important notices

Inspiro and DynaMic transmitters collect and store internal technical data.
The data may be read by a hearing care professional in order to check the transmitters, as
well as to support you in being able to use inspiro and DynaMic in the ideal manner.
Do not use your inspiro and DynaMic in a place where it is prohibited to use electronic
devices. If in doubt, please ask the person in charge.
Persons with pacemakers or other medical devices should ALWAYS consult their
physician, the manufacturer of their pacemaker, or other medical device BEFORE using
inspiro and DynaMic. The use of inspiro with a pacemaker or other medical devices should
ALWAYS be in accordance with the safety recommendations of the physician responsible
for your pacemaker or the pacemaker manufacturer.
Do not use two or more inspiro transmitters on the same FM channel, except in the case of
transmitters in a MultiTalker Network.
Please note that radio signals might also be picked up and overheard by other receivers.
Before using the inspiro in another country, contact your hearing care professional to make
sure the use of your radio channels is permitted in that country.
Do not use water or other liquids to clean the inspiro and DynaMic.
Use only original Phonak accessories.
Use only the original Phonak charger for inspiro and DynaMic.
Your inspiro and DynaMic may only be repaired by an authorized service center.
Dropping your inspiro and DynaMic could damage your equipment.
Do not place the rings to personalize your DynaMic over the openings of the microphone's
cap.
Do not cover the antenna or the microphone's cap, while speaking.
The microphone cap should be opened only for replacements reasons.
Please note that with inspiro you can adjust the volume of the iSense micro.
Your hearing care professional must program your inspiro by selecting iSense Micro as
FM receiver. This can be done with FM Successware 4.2.1 or higher.
18