2.
Install the module:
a.
Remove the new module from its ESD shielding packet in which it was shipped.
b.
Carefully insert the module into the slot and slide it along the slot's guide rails
until it makes contact with the card-edge connector located on the backplane.
c.
Using only the module handle, press the module into the chassis to engage it
with the chassis backplane.
d.
Connect all external interfacing cables to the module, as required.
Hardware Installation Manual
Figure 6-3: Module Handle Pushed In (Top View)
38
Mediant 4000 SBC
Document #: LTRT-41511