Hardware Installation Manual
Rear-Mounting Bracket x 2
To mount the device in a 19-inch rack using front- and rear-mounting brackets:
1.
Open the Rear Mounting Bracket kit and remove its contents. Make sure that all the
items are included in the kit (see above).
2.
Attach the two rear-mounting brackets to the two-rear rack posts, using two screws (not
supplied) per bracket. Make sure that you attach the brackets at the same height level
in the rack. See the figure below for correct orientation of the brackets when attaching
them to the posts.
Figure 4-2: Rear-Mounting Brackets Attached to Rear-Rack Posts (60 cm)
Figure 4-3: Rear-Mounting Brackets Attached to Rear-Rack Posts (80 cm)
Session Border Controllers
x 6
Rear-Mounting Flange x 2
23
4. Mounting the Device
x 6
Mediant 4000 SBC