Connecting To Power; Table 5-2: Power Specifications - AudioCodes Mediant 4000 SBC Hardware Installation Manual

Hardware Installation Manual
5.4

Connecting to Power

The procedure below describes how to connect the device to the power supply.
Power Supply
Input Ratings
Output Ratings
Connection to Electrical Outlet
Warnings:

The device must be connected (by service personnel) to a socket-outlet with a
protective earthing connection.

Use only the AC power cord supplied with the device.
Avertissements:

L'appareil doit être branché à une prise murale à condition qu'elle soit mise à la
masse.

Utilisez uniquement le cordon AC fourni avec l'appareil.
Notes:

You can connect both Power Supply modules (1 and 2), for 1+1 power load-
sharing and redundancy. Each module provides an AC power socket on the
device's rear panel. If both power modules are used, ensure that you connect each
one to a different AC supply socket.

The two AC power sources must have the same ground potential.
Session Border Controllers

Table 5-2: Power Specifications

Item
Up to two hot swappable, power supply modules for
power load sharing and AC power redundancy in
case of failure of one of the modules.
Single universal power supply 100-240 VAC, 50-60
Hz, 2.5A max.
12 VDC / 10 A max.
AC power supply inlet.
Description
33
5. Cabling the Device
Mediant 4000 SBC