Hardware Installation Manual
Figure 4-11: Front-Mounting Brackets Flush and Aligned with Front-Rack Posts (80 cm)
8.
Hold the chassis in position while the second person secures the two front-mounting
brackets to the front posts, by finger-tightening 19-inch rack bolts (not supplied) to the
rack posts.
9.
Tighten the bolts on the front-mounting brackets.
10.
With a Philips screwdriver, tighten the screws securing the rear-mounting flanges to the
rear-mounting brackets.
Notes:
Make sure that all the mounting brackets are attached at the same level to the
mounting posts so that the chassis is supported in a horizontal position.
If the depth of the rack exceeds the maximum length of the adjustable rear-
mounting brackets, install an additional side rack post to accommodate the length
of the rear-mounting bracket.
Session Border Controllers
27
4. Mounting the Device
Mediant 4000 SBC