Teledyne Piranha4 User Manual page 88

set - Set Exposure Time [ns]. See manual for restrictions on integration time
sfs - Select FlatField Color Selector <0-All,2-0Degree(R),3-90Degree(G),4-135Degree(B),5-
MONO>
sha - Set horizontal alignment in float <0-0Degree(R), 1-90Degree(G)> f<value 0-3>
shm - Set horizontal alignment mode < 0-Off, 1-Active>
smm - Mirroring <0:Off 1:On>
spf - Pixel Format <0:RGB8 1:RGB10 2:RGB12 3:BGR8 4:BGR10 5:BGR12 6:RGB8+MONO8
7:BGR8+MONO8 8:RGB12+MONO12 9:BGR12+MONO12>
ssa - Set Line Delay f<0-6>
ssb - Offset <0-System/1-0Degree(R)/2-90Degree(G)/3-135Degree(B)/4-MONO> <DN>
ssf - Internal Line Rate <Hz>
ssg - Gain <0-System/1-0Degree(R)/2-90Degree(G)/3-135Degree(B)/4-MONO> f<gain>
stm - External Trigger <0:Off 1:On>
sui - Set User ID '<string>
svm - Test Pattern <0-2>
usd - Default User Set <0-8>
usl - Load User Set <0-8>
uss - Save User Set <1-8>
vt - Temperature
vv - Input Voltage
Full Name Load Pixel Coefficients
Mnemonic LPC
Set selector
Argument(s)
Load user set
Description
Loads FPN coefficients and PRNU coefficients from a user set ( only coefficeints, no other
Notes
camera parameters)
Full Name Reset Camera
RC
Mnemonic
Argument(s)
Resets the camera to the saved user default settings. These settings are saved using the usd
Description
command.
Notes
Set Flatfield ROI
Full Name
Mnemonic ROI
First pixel
Argument(s)
Last pixel
Flat field region of interest
Description
Notes Specifies the pixels that CCF and CPA will calibrate
Pixel coefficients outside this region are not changed
Last pixel must be greater than or equal to first pixel
Full Name Reset Flatfield Coefficients
RPC
Mnemonic
88 •
0. Factory set
1-8. User sets
1 to 2048
1 to 2048
Appendix B: ASCII Commands