Consumer Information; Fcc Notices - BRINKS BHS i 100 User Manual

BrinksKeyPadPrinterSprd.2.22.06
Rechargeable Nickel-Metal-Hydride Battery Warning
• This equipment contains a rechargeable Nickel-Metal-
Hydride battery.
• Nickel is a chemical known to state of California to cause cancer.
• The rechargeable Nickel-Metal-Hydride battery contained in this
equipment may explode if disposed of in a fire.
• Do not short-circuit the battery.
• Do not charge the rechargeable Nickel-Metal-Hydride battery
used in this equipment in any charger other than the one
designed to charge this battery as specified in the owner's
manual. Using another charger may damage the battery or
cause the battery to explode.
Additional Battery Safety Precautions
Caution! To reduce the risk of fire or injury to persons by the
battery, read and follow these instructions:
1. Use only the Uniden battery pack specified in the owner's manual.
2. Do not dispose of the battery pack in a fire. The cell may
explode. Check the Nickel Metal Hydride battery disposal
package insert for disposal instructions.
3. Do not open or mutilate the battery pack. Released electrolyte is
corrosive and may cause damage to the eyes or skin. It may be
toxic if swallowed.
4. Exercise care in handling the battery in order not to short the
battery with conducting materials such as rings, bracelets, and
keys. The battery or conductor may overheat and cause burns.
5. Charge the battery pack provided with or identified for use with this
product only in accordance with the instructions and limitations
specified in the owners manual provided for this product.
6. Observe proper polarity orientation between the battery pack and
battery charger.
2/22/06 3:06 PM Page 6
48

Consumer Information

FCC Notices

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
FCC Part 15 Class B
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If interference generated by this unit is suspected, call Brink's
Customer Care at 1-800-445-0872.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Re-orient the radio/television antenna;
• Move the television or receiver away from the unit.
• Plug the unit and the TV/radio receiver into different outlets, i.e. not on the same
circuit breaker.
• Contact Brinks Home Security or an experienced TV/Radio technician for
additional suggestions.
• Review additional instructions on www.mybrinks.com.
Part Number SE 430; FCC ID: S9PSE430
Part Number BK 410; FCC ID: S9PBK410
Part Number IS440; FCC ID: S9PIS440
Part Number BS450; FCC ID: S9PBS450
ACTA Part 68
This equipment complies with Part 68 of the FCC rules and requirements adopted by the ACTA.
On the outside of this equipment is a label that contains, among other information, a
product identifier in the format US:AAEQ##TXXXX. If requested, this number must be
provided to the telephone company
The REN (Ringer Equivalence Number) is used to determine the number of devices that
may be connected to a telephone line. Excessive RENs on a telephone line may result in
the devices not ringing in response to an incoming call. In most but not all areas, the sum
of RENs should not exceed five (5.0). To be certain of the number of devices that may
be connected to a line, as determined by the total RENs, contact the local telephone
company. For products approved after July 23, 2001, the REN for this product is part of
the product identifier that has the format US:AAAEQ##TXXXX. The digits represented by
## are the REN without a decimal point (e.g. 03 is a REN of 0.3). For earlier products, the
REN is separately shown on the label.
Part Number SE 430; ACTA Registration Number: US:S9PAL01BSE430
i