Using The Grid Extender; Using The Keypad; Grid Identification Card - BRINKS BHS i 100 User Manual

BrinksKeyPadPrinterSprd.2.22.06
Communication Problem Indication
What it means: The system was unable to send an alarm or test signal to the
Brink's Monitoring Center.
What you'll notice: The keypad beeps four times per minute. The message
window displays CP TROUBLE, CALL 800-445-0872.
What to do:
1. To silence the keypad's beeping, press the CANCEL
key.
2. Check your telephone for a dial tone. If there is no
dial tone, remove the dialer cable from the telephone
jack leading to the grid extender. This disconnects
the system from the telephone line. It will not be
able to send an alarm signal to the Brink's
Monitoring Center.
3. Check your telephone for a dial tone. If the dial tone
returns, call Brink's Customer Care at 1-800-445-0872
for assistance.
4. If there is no dial tone, plug the dialer cable back
into the telephone jack. Contact your telephone
company for service.
Until the telephone service is repaired, no alarm
signals will be sent to Brink's. However, the system
should still work within your home. For your
protection, it is very important that you resolve
this problem quickly.
2/22/06 3:06 PM Page 34
34

Using The Grid Extender

The grid extender is designed to allow you to easily check whether it is
operational or not. Press the button in the center to see if the grid extender
is in operation. If the indicator light turns on, the grid extender is fully
operational. If the grid extender light is flashing, it indicates a low battery or a
communications failure. See page 33 to replace the battery.

Using The Keypad

The keypad(s) in your home is designed to be user-friendly. You will soon
learn the simple keypad commands which enable you to turn the system on
or off, test it or customize it. Follow the illustrations and instructions on the
following pages to learn all about your keypad commands.

Grid Identification Card

Zone 1: Front door
Zone 2: Back door
Sys. Component 1: Front keypad
Sys. Component 2: Grid extender
in den
Zone 3: Den center window
The Grid Identification Card helps you identify the location of each component
in your system. Each component listed will correspond with indicator codes on
the keypad.
11